THESE ARE SINGLE LED POCKET THROWERS. THEY USE SMOOTH REFLECTORS AND OSRAM WHITE LEDS WITH A 7135 DRIVER RUNNING BISCOTTI FIRMWARE. IF YOUR LOOKING FOR A THROWER IN A SUPER COMPACT SIZE THEN THIS IS YOUR LIGHT! THESE RUN ON A SINGLE 18650 BATTERY (NOT INCLUDED).
The interface is as follows:
While off: - Fully click and release to turn the light on. It will go to the
first mode or the last-used mode, depending on when you enabled mode memory.
- Short tap: Do a short (less than 0.5s) half-press to go forward to
the next mode.
- Long tap: Do a long (longer than 0.5s) half-press to reset to the first mode (if mode memory is turned off).
- Or fully click and release to turn the light off.
- Short tap a bunch of times (10+ taps, or until the light stops turning on) to enter config mode.
- Some mode groups have blinky modes. They are not hidden, but if you leave mode memory off you can skip them with a long press.
*Blinky modes include:
- Tactical police strobe (~8/16 Hz)
-Biking flasher (2-level stutter beacon, 1 Hz)
- Battery check / beacon mode
Each blink represents about 25% battery charge, so 1 is a low battery and 4 blinks is full. 5 blinks means it's over-charged.
The config mode has several options. It will blink out a number to show which option is active, then "buzz" or "stutter" for a bit.
Click during the "buzz" to select that option.
1. Mode group. After clicking, the light should come on in a special group-select mode. In this mode, it slowly blinks out numbers from 1 to N, where N is the number of mode groups, then repeats. Turn the light off after N blinks to select mode group N. BTW, do not leave the light in this mode for long periods of time, because it will wear out the driver's memory faster.
The mode groups are: (output is approximate)
1. 0.1%, 1, 10, 35, 100, strobe, biking, battcheck
2. 0.1, 1, 10, 35, 100
3. 100, 35, 10, 1, 0.1
4. 1, 20, 100, strobe, biking, battcheck, SOS
5. 1, 20, 100
6. 100, 20, 1
7. 0.1, 1, 10, 50, strobe, biking, battcheck, SOS
8. 0.1, 1, 10, 50
9. 50, 10, 1, 0.1
10. 1, 10, 35, 100
11. 100, 20, strobe
12. 100% only
Example: To select group 5 (low-med-high), let it blink until it counts out five, then click the button.
2. Mode memory. Off or on.